Industrial borescope（Waterproof Video Inspection System）testing procedures:
1.To understand the internal structure of the work-piece detection, detection of specific content, place. According to procedures related to start the instrument, check the power, the connection of the ground and the placement of the instrument whether or not reliable.
2.Choose the suitable probe, lens and enter into the product channel, before the test should be clear whether there are obstacles in the channel, burr, etc. Avoid something broke the product.
3. If have some do not understand the internal structure, suggest can observe first and use of observation lens and then detected, the detection of the lens and avoid to the detection area.
4. When detection should be adjusted before the eyes to adapt to the environment and light first, if the long hours of work should pay attention to avoid eye fatigue, missed product inspection.
5. During the inspection, be careful to ensure that the probe successfully reaches the designated location, the probe in the process of advancing in the face of significant resistance, should immediately stop moving forward, and should be slow to withdraw from, if being stuck, please do not pulling hard, avoid to damage work-piece.
6. The speed of the inspection for the probe not more than 10mm / s, should keep the image balance. When need for observation or large area scanning, should be used the straight line scan mode, each scanning width of not more than 20mm, and note that the probe observed range.
7. Processing and analysis of the collected images.
8. Clean the probe according to the instructions and clean up the site for the instrument and operate.
9. Suggested that the staff can use tools to help probe to best position.
没有评论:
发表评论